www.steerprop.com

 








<<back to products


Bollard Pull Trial Code
For Tugs With Steerprop Propulsors

Trial Site and Vessel Requirements


Positioning of the tug for bollard pull trials

The trial site should be carefully chosen to minimise the effect of the environmental conditions. The following minimum requirements have to be fulfilled with regard to trial site and vessel state.

Trial Site

Recommendation
The location for the trials should be chosen with no piers, docks, jetties breakwaters or other obstructions close to the tug.

The best place for the bollard is on a legged jetty with no wall, allowing the propeller wake to flow through/under the jetty. If a solid pier is chosen the bollard should be located as to give a clear run for the propeller wake, see figures. (click on the figures to enlarge)

Bollard Pull Code
Introduction
General
Trial Site and Vessel Requirements
  - Trial Site
- Water Depth
- Towline Length
- Draft and Trim
Environmental Conditions
Trial Procedures
Bollard Pull
Corrections